Smart Technologies 710.0026 instruction manual Programming Sensor Id Numbers

For dual-wheel assemblies, position the LF Initiator Tool approximately 1 inch (2.5 cm) away from the tire’s surface positioned at the center of the outboard tire’s sidewall opposite the valve stem. The transmission from the tool will pass through the outboard tire and provoke a data transmission from the sensor mounted on the inboard tire.

NOTE: Do not contact the tire or wheel surface when initiating data transmission from a sensor. Dual-wheel assemblies should always be mounted with valve stems 180° opposite each other.

PROGRAMMING SENSOR ID NUMBERS

Sensor ID numbers should be programmed by authorized SmarTire installation facilities using a Dealer Programming Tool (DPT). When programming a new sensor ID number, the installer must first configure the receiver so that it is ready to receive a new ID number, and then make the sensor transmit its ID number. The steps below describe how to program sensor ID numbers using the LF Initiator.

1.After connecting the DPT and installing all sensors, power on the system. Press and hold the ‘SET’ button on the DPT for more than two (2) seconds and less than five (5) seconds to enter the Full Programming Mode.

2.Press the ‘MODE’ button on the DPT to toggle between the different programming screens until the learn icon (a profile of a head containing a question mark) and a computer icon appear on the display. The DPT is now displaying the Sensor ID Number Programming screen.

3.Press the ‘TIRE’ button on the DPT to select Sensor ID Number Programming and the ten possible wheel positions for the primary vehicle will be displayed (windshield appearing on screen). The pre-programmed sensor positions are indicated by darkened tire icons.

4.Press the ‘TIRE’ button on the DPT to toggle to the desired wheel position. The flashing tire outline indicates the selected wheel position. When toggled past the primary vehicle, the display will show possible wheel positions for a tow-behind vehicle. Continue toggling past the axles of the two-behind vehicle to once again access the primary vehicle.

710.0026 R1.2 SmarTire LF Initiator Operating Instructions 5

REFERENCE ONLY