lWhen replacing the projector lamp:
oPut the projector into Standby mode and wait 30 minutes for the lamp to cool
completely.
oDo not remove any screws other than those specified in the lamp replacement
instructions.
oWear protective eyewear while changing the lamp. Failure to do so can cause injuries
including loss of eyesight if the lamp shatters or bursts.
oUse only replacement lamps approved by SMARTTechnologies. Contact your
authorized SMART reseller for replacement parts.
oNever replace the lamp assembly with a previously used lamp assembly.
oAlways handle the fragile lamp assembly with care to prevent premature lamp failure or
exposure to mercury. Use gloves when touching the lamp. Do not touch the lamp with
your fingers.
oRecycle or dispose of the lamp as hazardous waste in accordance with local
regulations.
You need a Phillips No. 2 screwdriver and a flat screwdriver to complete these procedures.
gTo remove the old lamp
1. Press the Power button on the ACP, and then select the Standby button to put the projector
into Standby mode.
OR
Press the Power button twice on the remote control to put the projector into Standby mode.
2. Wait at least 30 minutes for the projector to cool down.
3. Disconnect the power cable from the wall outlet.
C H A P T E R 6
Maintaining your interactive whiteboard system
48