SMC Networks 5MC2671W manual Hardware Description, Rear Panel

HARDWARE DESCRIPTION

The Wireless Ethernet Adapter supports 1, 2, 5.5 and 11 Mbps half-duplex connections to Ethernet networks. This device is fully compliant with 2.4 GHz DSSS CSMA/CA wireless networking as defined in IEEE 802.11b. It can be connected via an RJ-45 connection to devices such as Nintendo GameCube, Microsoft Xbox, Sony PlayStation II, and Ethernet ready embedded devices. It can also function as an IEEE 802.11b Access Point or as a Range Extender (see “Introduction” on page 1).

Power Connector			MDI/MDIX Switch
		RJ-45 Port
Figure 1.	Rear Panel
Item		Description
Power Inlet		Connect the included power adapter to this inlet.
		Warning: Using the wrong type of power adapter may damage
		your adapter.
LAN Port		Fast Ethernet port (RJ-45). Connect device (such as a PC, hub
		or switch) on your local area network to this port.
MDI/MDIX		Press down the switch to connect to a network device with a
Switch		straight-through twisted-pair cable; otherwise, connect to the
		network device with (MDI-X) station ports at both ends by using
		crossover cabling.

Note: If you use the RELOAD button at the bottom, the Wireless Ethernet Adapter performs a power reset. If the button is depressed for over 5 seconds, all the LEDs will illuminate and the factory settings will be restored.

3