Dell UCSE-900 manual Memory or battery problem error message, Firmware fault state error message

Memory or battery problem error message

Error Message:	Memory/Battery problems were detected. The adapter has
	recovered, but cached data was lost. Press any key to continue
Probable	The message occurs under the following conditions:
Cause:	• The adapter detects data in the controller cache that has not yet been written
	to the disk subsystem.
	• The controller detects an Error-Correcting Code (ECC) error while performing
	its cache checking routine during initialization.
	• The controller discards the cache rather than sending it to the disk subsystem
	because the data integrity cannot be guaranteed.
	• The battery may be under charged.
Corrective	Allow the battery to charge fully to resolve this problem. If the problem persists, the
Action:	battery or controller memory may be faulty. Contact Dell Technical Support.

Firmware fault state error message

Error Message:	Firmware is in Fault State.
Corrective	Contact Dell Technical Support.
Action:

Foreign configuration found error message

Error Message:	Foreign configuration(s) found on adapter. Press any key to
	continue, or ’C’ to load the configuration utility or ’F’ to
	import foreign configuration(s) and continue.
Probable	When a controller firmware detects a physical disk with existing foreign metadata,
Cause:	it flags the physical disk as foreign and generates an alert indicating that a foreign
	disk was detected.
Corrective	Press <F> at this prompt to import the configuration (if all member disks of the
Action:	virtual disk are present) without loading the BIOS Configuration Utility (<Ctrl>
	<R>). Or press <C> to enter the BIOS Configuration Utility (<Ctrl> <R>) and either
	import or clear the foreign configuration.

Foreign configuration not found in <ctrl> <R> error message

Error Message:	The foreign configuration message is present during POST but no
	foreign configurations are present in the foreign view page in
	<Ctrl> <R>. All virtual disks are in an optimal state.
Corrective	Ensure all your PDs are present and all VDs are in optimal state. Clear the foreign
Action:	configuration using <Ctrl> <R> or Dell OpenManage Server Administrator Storage
	Management.
	CAUTION: The physical disk goes to Ready state when you clear the foreign
	configuration.

102