Compliances
FCC Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
. Reorient the receiving antenna
. Increase the separation between the equipment and receiver
.Connect the equipment into an outlet on a circuit in a different room that to which the receiver is connected
.Consult the dealer or an experienced radio/TV technician for help.
Safety Compliance
Underwriters Laboratories Compliance Statement
Important! Before making connections, make sure you have the correct cord set. Check it (read the label on the cable) against the following:
Operating Voltage |
| Cord Set Specifications |
| |
| 120 Volts |
| UL Listed/CSA certified cord set |
|
|
|
| Minimum 18 AWG |
|
|
|
| Type SVT or SJT three conductor cord |
|
|
|
| Maximum length of 15 feet |
|
|
|
| Parallel blade, grounding type attach- |
|
|
|
| ment plug rated 15A, 125V |
|
| 240 Volts (Europe Only) |
| Cord Set with |
|
|
|
| three conductors with minimum diam- |
|
|
|
| eter of 0.75 mm2 |
|
|
|
|
| |
|
|
| Male plug rated 10 A, 250V |
|
|
|
|
|
|
