SMC Networks SMC2655W warranty Restore to Factory Defaults Procedure

Figure 1.2

Restore to Factory Defaults Procedure

1)Locate the [Default] button on the back of the SMC2655W Access Point.

2)Unplug the power from the back of the AP for 10 seconds.

3)Depress the [Default] button for 3 seconds.

4)Plug the power connector into the AP while depressing the [Default] button.

5)Release the [Default] button after 3 seconds. Wait 3 seconds and then depress the [Default] button again.

6)The "LNK/ACT" and "TX/RX" LEDs will blink once per second about 10-12 times. Release the [Default] button when these LEDs begin flashing rapidly.