SMC Networks SMC2671W System Requirements, Hardware, Status, Function, English, Power, Wireless

System Requirements

•A web browser, such as Microsoft Internet Explorer 5.5 or above installed on one PC at your site for configuring the Wireless Ethernet Adapter.

•CD-ROM drive.

•An AC power outlet.

•Wired or Wireless Network Adapter.

•An available RJ-45 (UTP) port on an Ethernet hub or switch.

•TCP/IP network protocol installed on each PC that needs to access the Internet.

English

Hardware

The EZ ConnectTM 11Mbps Wireless Ethernet Adapter supports 1, 2,

5.5and 11 Mbps half-duplex connections to Ethernet networks. This device is fully compliant with 2.4 GHz DSSS CSMA/CA wireless networking as defined in IEEE 802.11b. It can be connected via an RJ-45 connection to devices such as Nintendo GameCube, Microsoft Xbox, Sony PlayStation II, and Ethernet ready embedded devices. It can also function as an IEEE 802.11b Access Point or as a Range Extender.

The EZ ConnectTM 11Mbps Wireless Ethernet Adapter has three types of LED indicators. Please check the picture: the front view of the Adapter and the table below, which displays the current state the specific LED signifies.

LED	Status	Function
Power	On (Red)	Power on.
(PWR)	Off	No Power.
Wireless	Blinking (Green)	Wireless LAN
LAN		connection is
(TX/RX)		transmitting or
		receiving.
LAN	Blinking (Green)	Blinking: Wired LAN
(LINK/ACT)	On (Green)	connection is
		transmitting or
		receiving.
	Off (Orange)	On (Green): Device
		is connected at
		100Mbps.
		Off (Orange): Device
		is connected at
		10Mbps active.

English

3 4