SMC Networks SMC6724L2GLSC, SMC6724L2GSSC manual Handling the Modules, Instructions

INSTALLING THE MODULE

Handling the Modules

CAUTION: The modules can easily be damaged by electrostatic discharge.

To prevent electrostatic damage, observe the following guidelines:

•Do not remove the module from its packaging until you are ready to install it.

•Do not touch any of the module’s pins, connectors or components.

•Hold the module only by its edges or front panel.

•Wear an anti-static wristband connected to a suitable earth ground whenever handling the module.

•Store or transport this module only in appropriate anti-static packaging.

Instructions

CAUTION: The switch must be powered off before installing or replacing any module.

1.Power off the switch: Disconnect the AC power cord from the switch. If a redundant power unit (RPU) is present, disconnect its DC cable connection to the switch.

2.Remove network cables: If you are replacing a module, remove the cable attached to the port on the module.

3.Loosen the screws on the installed module or slot faceplate: Using your fingers or a flathead screwdriver, turn the screws securing the module (or faceplate on the slot) in a counter-clockwise direction until they are free of the chassis. Be sure not to completely remove the screws from the module or faceplate.

4