SMC Networks Wireless Broadband Router Hardware Installation, Panel Layout, Front Panel, Port

Chapter 2 Hardware Installation

2.1 Panel Layout

2.1.1. Front Panel

The front panel features three 10/100 Mbps Ethernet ports, one Wide Area network

(WAN) port, and diagnostic LED indicators. The WAN port connects your DSL or cable

modem to the router. The LAN ports are used to connect to your computers or other

network devices. LEDs monitor the status of each port.

Figure 2-1 Front Panel

RESET: To reset system settings to factory defaults, please follow these steps:

1.Power off the device,

2.Press the reset button and hold,

3.Power on the device,

4.Keep the button pressed for about 5 seconds,

5.Release the button,

6.Watch the M1 and M2 LEDs; they will flash 8 times and then M1 will flash once per second.

Port:

-7-