Smeg ALFA41VEK manual Instructions for the Installer, Installing The Oven, Safety thermostat

Instructions for the Installer

2. INSTALLING THE OVEN

The oven is designed for free-standing installation on a horizontal work- top. It must be far enough from the wall behind it to allow easy access to the terminal board for connection of the power supply lead. Installation must be carried out by a qualified engineer in compliance with the relevant EEC DIRECTIVES.

2.1Electrical connection

Check that the power supply voltage and size are as specified on the nameplate on the back of the oven. This nameplate must never be removed.

The oven is fitted with a H07RN-F three-core cable for operation at 230V∼ and power supply plug.

The power supply lead supplied is of 3 x 1.5 mm2 three-core H07RN-F type.

The power supply lead must be replaced by the manufacturer or an authorised service centre to prevent all risks.

The power supply plug and wall socket must be of the same type (in compliance with CEI standards). Check that the power supply line is properly earthed. The use of reductions, adapters or junctions is not recommended.

2.1.1 Safety thermostat

The oven is fitted with a safety device tripped in case of a serious malfunction. To reset the safety device, call the after-sales service.

The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance.

24