Fireplace
Installation
Continued
Installing Optional Brick liner Model BL32D
WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see Acces- sories, page 36.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Excessive force will break brick panels.
1.Remove top and bottom louvers to allow ac- cess to door latches.
2.Remove screen, unlock door latches and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 24.
3.If installing brick liner in new fireplace, go to step 4. If installing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 42).
6.Install left side brick panel by sliding it between grate and side of firebox (see Figure 43).
Rear Brick
Panel
Figure 42 - Installing Rear Brick Panel
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
9.Install logs, lava rock, and ember material see Installing Logs, Lava Rock and Glowing Embers.
10.Close glass door, lock latches on top and bottom of door and replace screen (see Removing/Re- placing Glass Door, steps 5 and 6, page 24).
11.Close top and bottom louvers.
Left Side
Brick Panel
Figure 43 - Installing Side Brick Panels
Installing logs, lava rock and glowing embers
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 24. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (rear log) on top of grate. Make sure notches in bottom of log fit over grate (see Figure 44, page 26).
2.Rest log #2 (front log) on pins on front part of grate (see Figure 45, page 26).
3.Place log #3 (crossover log) onto rear and front logs. Make sure it is seated properly on smooth surface of front log and pin on back log as shown in Figure 46, page 26.
4.Place log #4 (right log) onto pin on right side of front log as shown in Figure 47, page 26.
5.Place log #5 (base log) onto front left part of grate making sure notches fit over prongs of grate. See Figure 48, page 26.
www.desatech.com | 25 |
