Desa (V)T32N SERIES, (V)T32P SERIES Removing/Replacing Glass Door, Removing Louver Panel

Models: (V)T32N SERIES (V)T32P SERIES

1 40
Download 40 pages 37.59 Kb
Page 24
Image 24
Removing/Replacing Glass Door

Fireplace

Installation

Continued

Removing/Replacing Glass Door

Figure 40 - Removing Louver Panel CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For replacement part informa- tion see Replacement Parts, page 36.

Figure 41 - Removing/Replacing Glass CAUTION: Wear gloves and safety glasses while handling or removing broken glass. Do not remove if glass is hot. Keep children and pets away from glass.

Manual background WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before re- moving glass door or louvers.

Removing Louver Panels

Remove the top and bottom louver panels by si- multaneously pulling both top end spring latches towards the center of the appliance until they are disengaged from the locating holes (see Figure 40). Repeat for bottom spring latches and pull the lou- vers outward. To install or replace items removed, simply reverse the procedures above.

Manual backgroundManual background Spring

Latch

Manual background Louver Panel

Figure 40 - Removing Louver Panel

Removing Glass Door

If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.

1.Remove screen assembly by pushing the rod either left or right and then down and forward to remove screen/rod assembly from the fire- box. Set assembly aside.

2.Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 41).

3.While holding glass door to prevent it from falling and causing injury, remove the five screws from the hinge located on the left side of door frame assembly (see Figure 41).

4.Remount the new frame at the hinge with five new screws before closing door. This will ensure seating of the gasket.

5.Close glass door frame. Lock latches by placing the bar under the tab on door and pushing down and back on latch (see Figure 41).

6.Replace screen/rod assembly by reversing step 1.

7.Replace louvers by reversing procedure under

Removing Louver Panels.

Unlock Manual backgroundManual backgroundManual backgroundManual background Lock Latch

Screw

Hinge

Glass

Frame

Assembly

Figure 41 - Removing/Replacing Glass

Door

Cleaning Glass Door

See Cleaning and Maintenance on page 30.

24

www.desatech.com

111986-01D

Page 24
Image 24
Desa (V)T32N SERIES, (V)T32P SERIES installation manual Removing/Replacing Glass Door, Removing Louver Panel