OPERATIng fireplace
Continued
Manual Lighting
Procedure
1.Remove glass door (see Removing/Replacing Glass Door, page 24.)
2.Follow steps 1 through 7 under Lighting Instructions, page 27.
3.Depress gas control knob and light pilot with match.
4.Keep gas control knob pressed in for 30 seconds after lighting pilot. After 30 sec- onds, release gas control knob. Follow steps 9 through 12 under Lighting Instructions, page 27.
5.Replace glass door (see Removing/Replacing Glass Door, page 24).
OPTIONAL Hand-Held
IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.
On/Off Series
(Models HRC100 and HRC101)
Hold the control button on the
To Lock press both buttons on
To Unlock press both buttons together on
REMOTE OPERATION
Note: All remote control accessories must be purchased separately (see Accessories, page 36). Follow instructions included with the remote control.
Indicator Light
Control Button
NOTICE: You must light the pilot before using the
After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere be- tween HI and LO. Slide the selector switch to the REMOTE position (see Figure 51). Note: The burner may light if
Figure 52 - On/Off Hand-Held Remote
Control Unit HRC100
Thermostat Series
(Model HRC200 and HRC201)
The
Manual Mode
1. Press the POWER and LOCK buttons together to turn on the
Blower Control Knob (Optional Accessory)
Variable Control Knob
control.
2. Press the MANU button to turn on the fireplace.
OFF
REMOTE
OFF
ON
ON
N |
|
| |
O |
| L |
|
T |
| O | I |
O |
| O | H |
L |
|
| |
I | F |
| |
| P F |
| |
|
|
|
|
3. Press the POWER and LOCK buttons together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons together to turn on the
Gas Control Knob in
Selector Switch in ON Position
Remote Position
Figure 51 - Setting the Selector Switch,
Gas Control Knob and Variable Contorl
Knob for Remote Operation
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press- ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons together to turn off the fireplace
28 | www.desatech.com |