Fireplace
Installation
Continued
Installing optional wall mount switch - GWMS2
1.Connect one terminal of 25 ft. wire for wall switch to TPTH terminal on the valve. Con- nect remaining wire terminal to the TH termi- nal on the valve. Make sure wire terminals are in positions on unit as pictured in Figure 36. If wires are not connected as shown, switch will not work.
2.Route 25 ft. wire through openings provided on sides of burner system to a convenient location to mount your switch.
3.Connect one bare wire end to each terminal of GWMS wall switch.
4.Install wall switch and cover in the wall.
To Wall
Switch
Accessory
Figure 36 - Attaching Alkaline Battery to
Receiver
Installing Optional Wireless
NOTICE: Use only alkaline bat- teries (not included).
Installing Remote Receiver
1. Open bottom louver and locate the switch
Receiver 
Battery
Terminal
Wires
Battery Clip
Figure 37 - Attaching Alkaline Battery to
Receiver
To Optional
Remote
Accessory
Figure 38 - Control Valve Terminals
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to a
3. Replace battery cover onto remote control unit.
Remote
BatteryControl Unit
Cover
bracket on the left.
2. Unscrew the switch bracket. Lean bracket
Terminal
Battery Housing
forward so you are able to access the back of the remote receiver.
3. Locate the battery clip mounted on the back of the receiver. Slide a
4. Attach the terminal wires to the battery.
5. Connect wires from receiver to TH and TPTH to control valve (see Figure 38).
6. Replace the switch bracket.
Wires
Battery
Figure 39 - Installing Alkaline Battery in
Hand-Held Remote Control Unit
www.desatech.com | 23 |
