6Solution suggestions for problems
Drying process takes too much time
•Meshes of the filter may be clogged. Wash with water. Laundry come out wet at the end of drying.
•Meshes of the filter may be clogged. Wash with water.
•Excessive laundry might have been loaded in. Do not overload the machine.
Machine does not switch on or the program does not start. Machine is not activated when set.
•It might have not been plugged in. Make sure that the machine is plugged in.
•The loading door may be ajar. Make sure that the loading door is properly closed.
•Program might have not been set or the «Start/Pause/Cancel» button might have not been pressed. Make sure that the program has been set and it is not in “Pause” mode.
•«Childproof lock» might have been activated. Deactivate the childproof lock.
•The condenser cover on the models with a condenser might not be closed securely. Make sure that the condenser cover and the red lock is closed securely.
Program has been interrupted without any cause.
•The loading door may be ajar. Make sure that the loading door is properly closed.
•Electricity may be cut off. Press «Start/Pause/Cancel» button to start the program.
•The condenser cover on the models with a condenser might not be closed securely. Make sure that the condenser cover and the red lock is closed securely.
Laundry has shrunk, become felted or deteriorated.
•A program suitable for the laundry type might have not been used. Dry only the laundry which is suitable for drying in your machine after checking the labels on your clothes.
•Select a program with suitable low temperature for the laundry type to dry your clothes.
Drum lightning does not come on. (for models equipped with a lamp)
•The machine might have not been started by using the On/Off button. Make sure that the machine is On.
•Bulb may have blown. Call the authorized service to replace the bulb.
•The condenser cover on the models with a condenser might not be closed securely. Make sure that the condenser cover and the red lock is closed securely.
2 beeps heard when the buttons are pressed or the program selection knob is turned.
•Childproof lock» might have been activated. Deactivate the childproof lock.
•Program selection knob might be turned to an undefined position. Select one of the defined programs.
“Filter cleaning” light is flashing.
• Filter might have not been cleaned. Clean the cover filter.
“Final /
• Program has come to an end. Turn off the machine and take out the laundry.
3 beeps are heard when you press the Start/Pause/Cancel button
•The loading door may be ajar. Make sure that the machine is plugged in.
•Make sure that the condenser cover and the red lock is closed securely.
Also for products equipped with a condenser:
“Water tank” warning LED is flashing.
•Water may be full.
•Drain the water in the water tank.
A Call an authorized service agent if the problem persists.
20 - EN
