![](/images/new-backgrounds/1255101/25510165x1.webp)
Problem solving guide
With the help of the following notes minor faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Service Department.
Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages
Problem | Possible cause | Remedy |
The electronic system lock is | You will need to deactivate | |
the display. | activated. | the system lock before the |
The Low |
| dryer can be used (see |
temperature |
| "Electronic system lock"). |
indicator light is |
|
|
flashing. |
|
|
The programme | This is not a fault. | Use the Warm air |
stops and | The electronic unit has | programme for drying |
0 and Finish | recognised that there is no | individual items. |
appear in the | laundry or insufficient laundry | – Open and shut the door. |
display. | in the drum and cancelled the |
|
The buzzer | programme. Drying individual |
|
sounds. | garments or items which are |
|
| already dry can also cause the |
|
| programme to be cancelled. |
|
The programme | No obvious cause. | – Switch the dryer off and |
stops. |
| back on again. |
The buzzer |
| – Then start the programme |
sounds. |
| again. |
Cooling down or |
| If this problem happens |
Finish may also |
| again, there is a fault. |
flash in the |
| Contact Miele. |
display. |
|
|
Bars are | The programme has finished | You can either unload the |
flashing at the | but the laundry is still being | drum and leave the laundry |
end of the | cooled down. | to cool at room temperature |
programme: |
| or leave it in the dryer to |
| continue cooling. |
33