Installation and connection
Levelling the machine
The machine must be perfectly level to ensure safe and proper operation.
The screw feet can be adjusted to compensate for any unevenness in the floor.
The air inlet and outlet vents on the front and back of the machine must not be covered as this would prevent sufficient ventilation for cooling the condenser unit.
Do not block the gap between the bottom of the tumble dryer and the floor with plinth facings, deep file carpet etc. This would hinder a sufficient flow of air to the dryer.
Room ventilation
The air which is taken in when the dryer is in operation is blown out of the front of the dryer and warms up the air in the room. It is very important to ensure adequate ventilation, e.g. by opening a window. Otherwise drying times maybe longer.
Before moving the tumble dryer again (e.g. when moving house)
After each use a small quantity of condensed water will collect in the area around the pump. This water can run out if the dryer is tipped up when it is being moved. It is a good idea to run the Warm air programme for approximately 1 minute before moving it. Any remaining condensed water will then be fed into the condensed water container or out through the drain hose.
43
