Smeg C9GMXA manual Instructions for the installer, Installing The Appliance, Electrical connection

Instructions for the installer

2. INSTALLING THE APPLIANCE

IIt is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AS5601.

2.1 Electrical connection

After making the electrical and gas connections, level the the appliance on the ground by means of its four adjustable feet. For good cooking results, the appliance must be properly levelled. Depending on the model you have purchased, the foot height adjustment range may vary from 70 to 95 mm and from 110 to 160 mm. These heights refer to the distance between the highest point of the foot (fixed part) and the lowest point (movable part which rests on the floor).

2.2 Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

The plug on the end of the power supply cable and the wall socket must be of the same type (in compliance with the relevant national standards). Check that the power supply line is properly earthed. The use of reductions, adapters or junctions is not recommended.

The appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.

For operation on 380-415V 3N~: use an H05V2V2-F type five-core cable (5 x 1.5 mm2).

For operation on 380-415V 3N~: use an H05V2V2-F type four-core cable (4 x 1.5 mm2).

For operation on 220-240V~: use an H05V2V2-F type three-core cable (3 x 2.5 mm2).

The earth wire (yellow-green) must be at least 20 mm longer than the other wires at the end for connection to the appliance.

The manufacturer declines all responsibility for damage to persons or things caused by non- observance of the above prescriptions.

6