Step 5 — Install Flue Hood
48AJ,AK,AW,AY051 AND 060 UNITS — Flue hood and wind baffle are shipped inside gas section of unit. To install, se- cure flue hood to access panel. Install the two pieces of the wind baffle over the flue hood. See Fig. 15.
NOTE: When properly installed, flue hood will line up with combustion fan housing. See Fig. 16.
Fig. 14 — Flue Hood Location
GAS SECTION
ACCESS PANEL
FLUE HOOD
WIND
BAFFLE
TOP VIEW | SIDE VIEW |
Fig. 15 — Flue Hood Location
(48AJ,AK,AW,AY051 and 060 Units)
Fig. 16 — Combustion Fan Housing Location
Step 6 — Trap Condensate Drain — See Fig.
Condensate pans are sloped so that water will completely drain from the condensate pan to comply with indoor air quali- ty guidelines. The condensate drain pans are not insulated.
Fig. 17 — Condensate Drain Trap Piping Details
(Typical Roof Curb or Slab Mount Shown)
Step 7 — Install Gas Piping — Unit is equipped for use with natural gas. Installation must conform with local building codes or, in the absence of local codes, with the Na- tional Fuel Gas Code, ANSI Z223.1.
Install manual gas shutoff valve with a
WARNING
Do not pressure test gas supply while connected to unit. Always disconnect union before servicing. Serious injury could result.
19