Smeg CS15-5 manual Installer Instructions, 2.4.2Butane/propane gas connection

Installer Instructions

2.4.2Butane/propane gas connection

For butane, use a pressure regulator on the gas cylinder in accordance with the regulations in force and a flexible hose in accordance with Standard XPD36-110. Screw hose-end fitting A onto the end of pipe B of the appliance, interposing seal C between the two, carefully thread on flexible hose D and fix the hose to the hose-end fitting using safety collar E. The flexible hose may only be used if the appliance has been installed in isolation from the network or if the full length of the hose is visible. For propane, see paragraph “2.4.3 Connection using a collapsible steel tube”.

2.4.3Connection using a collapsible steel tube

The gas can be connected using a flexible rubber hose (Standards NFD36-100 and NFD36-103 for methane; Standard XPD36-112 for butane) or using a collapsible metal tube (Standard NFD36-121 for methane; Standard NFD36-125 for liquid gas). Where a flexible rubber hose is used, please observe the requirements set out in the paragraph marked "Important".

The connection point on the appliance is a threaded ½” male gas connection.

2.4.4Natural gas connection

The gas can be connected using a flexible rubber hose (Standards NFD36-100 and NFD36-103 for methane; Standard XPD36-112 for butane) or using a collapsible metal tube (Standard NFD36-121 for methane; Standard NFD36-125 for liquid gas). Where a flexible rubber hose is used, please observe the requirements set out in the paragraph marked "Important".

Flexible hose/collapsible tube L must be connected directly to the end of pipe B of the appliance, interposing seal C between the two. The connection point on the appliance is a threaded ½” male gas connection.

2.4.5Butane/propane gas connection

Use a pressure regulator in accordance with the regulations in force and carry out the connection to the cylinder in accordance with the regulations in force. Make sure that the feed pressure is in accordance with the values specified in the table in paragraph "3.2/3.3 Tables for burner and injector characteristics"

Screw hose guide F onto hose guide A; connect the resulting assembly to gas fitting B (or use hose guide G which must be connected directly to gas fitting B) and interpose seal C in between the two. Mount the ends of rubber hose H onto hose guides A+F (or G if appropriate) and the outlet fitting of the pressure regulator onto the cylinder. Fix the ends of hose H onto hose guides A+F (or G if appropriate) using bearing I in accordance with the regulations in force.

Hose-end fittings A-F-Greferred to above are not provided with the appliance. Use hose- end fittings that meet the requirements of the regulations in force only.

8