Smeg CS15-5 manual Installer Instructions, Installing The Appliance, 2.1Electrical connection

Installer Instructions

2 INSTALLING THE APPLIANCE

The appliance must be installed by a qualified technician and in accordance with the regulation s in force.

It can be installed against walls where one of them is higher than the hob as illustrated in figures A and B in relation to the installation classes. The hanging furniture and suction hoods located above the hob must be at least at a distance of 750 mm.

A B

2.1Electrical connection

Make sure that the voltage and size of the supply cable correspond to the characteristics detailed on the identificationplate inside the storage compartment. Do not remove this plate for any reason.

If the appliance is connected to the power grid by means of a fixed connection, an all-pole switch must be installed on the supply cable with a contact opening distance of at least 3 mm, and it must be located close to the appliance in a readily accessible place.

The connection to the power grid may be permanent or by means of a plug and socket. In the latter case, they must be suitable for the cable in use and must meet the regulations in force. The appliance must be earthed for every type of connection. Before it is connected up, you must ensure that the supply cable is equipped with a suitable earth electrode. Avoid using adaptors which could cause overheating.

In case of replacement of the supply cable, the wire section of the new cable should be no less than 1.5 mm2 (3 x 1.5 cable), taking into account the fact that the termination to be connected to the appliance must have an earth wire (yellow/green) at least 20 mm longer. Use a H05V2V2-F cable or equivalent, excluding all other cable types. The cable must be resistant to a maximum temperature of 90°C. It must be replaced by a specialised technician who will need to connect it to the power grid in accordance with the appropriate diagram.

L = brown N = blue

= yellow/green.

6