Smeg DO10PSS manual Door glass, Maintenance, Replacement of light bulb, Instructions for the user

Instructions for the user

13.3.4 Looking after the self-cleaning liners

The liners should not be cleaned with abrasive creams or ordinary detergents. Use a damp sponge only, so as not to damage the special characteristics of the enamel which coats the liners.

13.3.5Assembling the self-cleaning liners

1.Remove all accessories from the oven;

2.Remove the side grilles (fig.1);

3.Extract the side liners “F” and “G”(fig. 2);

4.Remove the back panel “A” after undoing the threaded ring-nut “C” (fig. 2).

5.Reassemble the panels, restoring them to their original position.

1) 2)

To remove the self-cleaning liner at the back of the small oven, extract it from the two screws on the bottom of the oven. To replace it, align the two holes on the liner with the two screws on the bottom and pull down until engaged.

13.4 Door glass

The door glass should always be kept clean. Use absorbent kitchen paper to clean. In case of tough spots, clean with a damp sponge using regular detergent. This oven door is air cooled. Care should be taken not to use excess moisture for cleaning, and avoid spillage through the vents.

MAINTENANCE

The oven may require maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations.

Before any intervention, disconnect the power supply of the device.

13.5 Replacement of light bulb

Remove the bulb protector A by turning anticlockwise and change bulb B with a similar one. Re-fit the bulb protector A.

Only use oven bulbs (T 300°C).

47