AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.See if you can solve the problem yourself with the help of the
2.Switch the appliance on again to see if the problem has been solved. If it has not, disconnect the appliance from the power supply and wait for about an hour before switching on again.
3.If the problem persists after this course of action, contact
Specify:
•the nature of the problem
•the model
•the Service number (the number after the word SERVICE on the rating plate on the inside of the appliance)
•your full address
•your telephone number and area code
Note:
The direction of door opening can be changed. If this operation is performed by
INSTALLATION
•Install the appliance away from heat sources. Installation in a hot environment, direct exposure to the sun or installation near heat sources (heaters, radiators, cookers) will increase power consumption and should therefore be avoided.
•If this is not possible, the following minimum distances must be respected:
•30 cm from coal or paraffin stoves;
•3 cm from electric and/or gas stoves.
•Fit the spacers (if supplied) on the rear of the condenser positioned at the back of the appliance.
•Install the appliance in a dry,
•Clean the interior.
•Fit the accessories.
Electrical connection
•Electrical connections must be made in accordance with local regulations.
•Voltage and power consumption are indicated on the rating plate inside the appliance.
•Regulations require that the appliance is earthed.
The Manufacturer declines all liabilities for injury to persons or animals or damage to property resulting from failure to observe these regulations.
•If the plug and socket are not of the same type, have the socket replaced by a qualified electrician.
•Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or by means of a
21
