RECIRCULATION VERSION AIR OUTLET
•Assemble the two halves of the hood body extension piece 14 (if necessary).
•Push fit the assembled hood body extension piece 14 onto the air outlet (if necessary).
•Push fit connection 15 onto the hood body extension piece 14 or directly onto the hood body.
•Insert the connection extension pieces laterally 14.1 in connec-
tion 15.
Should the central reinforcing piece of the frame somehow inter- fere the chimney air outlet grille, it is possible to unscrew it and to place it in another screw hole set.
15
14.1
14
Flue assembly - Mounting the hood body
• Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2,9 x 6,5) provided.
• Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2,9 x 6,5) pro- vided.
12c
8b | 8a |
|
Recirculation version
•Make sure that the outlet of the extension pieces 14.1 is hori- zontally and vertically aligned with the chimney outlets.
•Otherwise, remove the lower chimney and adjust the position by inverting the extension pieces for air outlet connection 14.1 or by cutting the hood body extension piece 14 (if any) along one of the chases destined to the predetermined extension lengths. Replace then the elements as earlier described.
•Fit the directional grids 8a - 8b in their housings making sure
that the directional symbols are towards the top. Also make sure that they are correctly inserted in the connection exten-
12c
12f
12q
22
B
sion pieces 14.1.
Before fixing the hood canopy to the frame:
•Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame.
•Remove the grease filters from the hood canopy.
•Remove any activated charcoal filters.
•Lift the hood canopy and engage the screws 12f in the slots (A) as far as they will go.
•Working from below, fix the hood canopy to the frame (B), using the 4 screws 12q and 4 washers 22 provided, then tighten all the screws securely.
A
EN |
| 1 |
| 19 |
