Activated Charcoal Filter (Recirculation Version)
•This cannot be washed or regenerated, and must be changed when all the command LEDs start to flash, or at least once every 4 months.
Activating the alarm signal
•In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date.
•Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be dis- played:
•Leds
•Leds
VATED.
CHANGING THE ACTIVATED CHARCOAL FILTER
Resetting the alarm signal
• Press any of the buttons except the Light button.
Changing the Filter
•Remove the Metal grease filters.
•Remove the saturated Activated Charcoal filter, as shown in the figure.
•Fit the new Filter, hooking it into place.
•Replace the Metal grease filters.
Lighting
LIGHT REPLACEMENT
20 W halogen light.
• Remove the
•Remove the halogen lamp from the lamp holder by pulling gently.
•Replace the lamp with a new one of the same type, making sure that you insert the two pins properly into the housings on the lamp holder.
•Replace the
EN |
| 2 |
| 23 |