| Mounting the hood body |
|
• | Before attaching the hood body, tighten the two screws Vr lo- | Vr |
| cated on the hood body mounting points. | |
|
| |
• | Hook the hood body onto the screws 12a. |
|
• Fully tighten the support screws 12a. |
| |
• | Adjust the screws Vr to level the hood body. | 12a |
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer.
•To install a ø 120 mm air exhaust connection, insert the re- ducer flange 9 on the hood body outlet.
•Fix the pipe in position using sufficient pipe clamps (not sup- plied).
•Remove possible charcoal filters.
RECIRCULATION VERSION AIR OUTLET
•Push fit connection 15 onto the hood body outlet.
•Insert the connection extension pieces laterally 14.1 in connec- tion 15.
•Make sure that the outlet of the extension pieces 14.1 is hori- zontally and vertically aligned with the chimney outlets. If this is not the case, adjust the position by either reversing the con- nection extension pieces 14.1 and then reassemble as described previously.
•Ensure that the activated charcoal filters have been inserted.
ø 150 | ø 120 |
9
1514.1
EN |
| 6 |
| 6 |