Smeg KSE 91X, KSE 61X, KSE 71X manual

The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special anti-grease products. They can also be washed in a dishwasher. In this case, it is advisable to stack them vertically to avoid food residues to stick to them.

Dishwasher cleaning may damage the metallic surface (blackening it), although this will not affect its fat retention capacity.

Once clean, leave them to dry off and then fit them back to the kitchen hood.

Changing light bulbs

Proceed as follows:

• Remove the metal filters.

• Change the broken/burnt out lamp. Maximum lamp power is 40W (E-14).

• Fit the metal filters.

Cleaning and maintenance

During cleaning and maintenance work, make sure the safety instructions set out on page 14 are fully satisfied.

Cleaning the hood body

• If your kitchen hood is made from stainless steel, use suitable cleaners mentioned in the product instructions.

• If your kitchen hood is painted, use lukewarm water and a neutral soap.

• Never use metallic scourers, nor abrasive or corrosive products.

• Dry the kitchen hood using a cloth that does not produce fibres.

• The use of vapour cleaners is not recommended.

Cleaning the metal filters

To remove the filters from their fittings, press lightly on the locks and then pull them off.

_________________________________________________________

Problem solving

Proceed with the following checks before calling the Technical Service:

GB

Sizes and specifications

See page 39.

SMEG reserves the right to make changes and corrections to its products as it deems necessary, without altering their basic characteristics.

16