Smeg KSEG76X Installation, Drilling the Support surface and Fitting the Hood, Snap-Onfitting

INSTALLATION

Drilling the Support surface and Fitting the Hood

Make a rectangular opening on the base of the hanging unit, leaving a minimum of 13 mm from the outer edges.

Hood Type	52	70
L1	497	677	259

13

L1

SNAP-ON FITTING

For hoods with snap-on side supports only, set up for a support panel thickness of between 15 mm and 30 mm.

• Insert the hood until the side supports snap into place.

• Lock in position by tightening the screws Vf from underneath the hood.

Vf

GB 12