Auto Page RS-622 manual If installed, To Override Vehicle From Remote Start Control, Enter

2.Move the optional remote start enable toggle switch to OFF position.

(If installed)

3.Press the brake pedal, the vehicle will shut down and turn off the parking light to indicate engine stopped.

TO OVERRIDE VEHICLE FROM REMOTE START CONTROL:

To operate the vehicle while it is running from the remote start:

1.Insert the ignition key and turn it to “ON” (not the start) position.

2.Press the brake pedal.

Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.

TEMPORARY STOP FEATURE:

This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the engine running and the climate control on.

1.Before turning off the engine, press the button once on the transmitter. The parking lights will come on and the LED will flash 3 times to confirm Temporary Stop feature ‘ON’

2.Turn the ignition key to OFF position. (The engine will stay running.)

3.The engine will run until the pre-programmed time elapsed or shutdown input is received.

TIMER START: You must fully understand this feature to operate the remote start safely. Use caution in using this feature.

This unit can be programmed to start and run the engine every 3 hours. The engine will run for the programmed run time and then shut down.

IMPORTANT: Timer Start should be used only in open areas, NEVER start and run the vehicle in on enclosed space such as a garage or carport.

Three hours timer start: This feature is design for an extreme cold climate usage. The system will auto start the vehicle every 3 hours, to prevent engine freezing and hard to start.

A maximum of six cycles can occur.

ENTER:

1.Press the button once to remote start the vehicle. As soon as the vehicle is running the parking lights will turn ‘ON’.

2.Immediately press the button then press button. The parking light will flash (3) times. The siren chirps (3) times. The vehicle is now programmed to start every (3) hours.

3.Press the brake pedal to stop the vehicle running.

7