SIEMENS 5881 Broadband Internet Router | Chapter 2 Installation |
User’s Guide | Hardware Installation |
|
|
Hardware Installation
You may position the Siemens broadband router at any convenient location where it will be well ventilated. Do not stack it with other devices or place it on the carpet. You can connect the router to an existing Ethernet port on your computer.
To connect the SpeedStream device via the Ethernet interface, your computer must have an Ethernet adapter (also called a network interface card, or NIC) installed. If your computer does not have this adapter, install it before proceeding further. Refer to your Ethernet adapter documentation for complete installation instructions. Once you verify installation of an Ethernet adapter, perform the following procedure to connect the router to your computer.
To set up the harware connections:
1.With the PC powered off, connect your PC directly to any of the router’s Ethernet ports on the
2.Connect the other end of the Ethernet cable to the Ethernet port on the PC.
3.Connect your Ethernet Interface WAN device (broadband modem or similar) to the Ethernet port labeled UNTRUSTED, using another
4.Optionally connect the MGMT port to one of the following:
•Your PC serial port using another
•An external using an
5.Connect the power adapter to the rear of the router.
6.Plug the power adapter into the electrical wall outlet.
7.Flip the power switch on the router.
8.Power on all connected computers.
You can now configure the TCP/IP settings as detailed in the PC Configuration section.
SIEMENS | 7 |
