Instructions for the installer

Hole in top of supporti ng unit 560 mm

10.4 Positioning of the hob

The following operation requires building and/or carpentry work so must be carried out by a competent tradesman.

Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they are heat resistant (T 90°C).

Create an opening with the dimensions shown in the figure in the top surface of the counter, keeping a minimum distance of 50 mm from the rear border.

This appliance can be mounted against walls higher than the work surface on condition that a certain distance “X” be kept between the appliance and the wall as shown in the figure so as to avoid damage from overheating. Make sure there is a minimum of 750 mm between the hob and any shelf that may be installed directly above them.

The only model requiring a hole of 685 mm in the top of the supporting unit is the model with 5 cooking zones and central fish plate.

Accurately position the gasket provided all around the outer edge of the hole in the top surface as shown in the figures below, pressing it down so as to make it adhere properly. For measurements, refer to the figure depending on the hob model to be installed, bearing in mind that in both models the front and rear sides must skim the hole. Secure the hob to the counter with brackets A (supplied). Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket.

Hole

in

Accurately position the gasket provided all

top

of

around the outer edge of the hole in the top

supporti

surface as shown in the figures below, pressing it

ng

unit

down so as to make it adhere properly. Refer to

685mm

the dimensions shown in the diagram, bearing in

 

 

mind that the sides A must be flush with the hole.

Fix the hob to the unit using the brackets B provided.

Carefully trim any excess from border C of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket.

31

Page 14
Image 14
Smeg P662-1, P652, P662B-1 manual Positioning of the hob, Hole in top of supporti ng unit 560 mm