Instructions for the user
7.2.3 Plate lock-out
20 seconds after the last power adjustment, the plate switches to
The 
or 
symbol of any
7.2.4 Plate layout
REAR LEFT | REAR RIGHT |
FRONT LEFT | FRONT RIGHT |
7.2.5 Timer (on some models only)
MIDDLE
Some models are equipped with cooking timer.
To activate the timer, proceed as follows: with the plates on or off;
1.keep the 
symbol pressed for a few seconds (the two displays in the middle of the screen- printing will switch on, showing a flashing figure 30) (if the plate is on, the power display value will drop by one point, but it will return to the previous value at once);
2.press the 
or 
symbols to increase or reduce the cooking time and set it on the number of minutes required (the number of minutes flashes);
3.seconds after the last key is pressed, the minutes display will stop flashing and the figure 0 on the power display will start to flash.
4.The power level must be set within another 5 seconds as described in points 7.2.1 / 7.2.2; otherwise the hob will switch off automatically. If the power is not adjusted within 5 seconds, the timer will still start the count.
5.Timed cooking will start 5 seconds after the last power adjustment.
At the end of the time set, 3 BEEPS will sound in sequence; they are repeated 5 times at 5 second intervals.
To stop the beeps in manual mode, simply press the 
or 
symbol of any
7.2.6 Modifying the data set
During timed cooking, each single pressure on the 
or 
symbols increases or reduces the power of the plate. 5 seconds after the last button is pressed, a BEEP will sound and the display showing the time left will start flashing. The 
or 
symbols can now be pressed to increase or decrease the cooking time.
A few seconds after the last cooking time adjustment, the minutes display will also stop flashing and the count will restart with the new settings.
7.2.7 Residual heat
Each plate is equipped with a residual heat warning device.
After any plate is switched off, a flashing "
" may appear on the display. This warns that the cooking zone concerned is still very hot.
Cooking can be restarted while the 
is flashing; proceed as described in points "7.2.1 / 7.2.2".
7.2.8 Control circuit board thermal protection
If the plates overheat the internal electronics board, the heat will be switched off automatically. This
switches off power to the front plates, and the letters 
and 
flash alternately on the power leds. If the electronics board does not cool down, power to all the plates is switched off, and the power leds
display the text 
. Cooking can be resumed once the temperature has dropped below the safety threshold.
7.2.9 Operator Error
If the user makes a mistake when using the 
appears on the power display; it will remain there as long as the user continues to press the button being used incorrectly.
26
