Smeg PGF95BE-1, PGF95-1, PGF95F-1 manual Electrical connection, Instructions for the installer

Instructions for the installer

2.3Electrical connection

Make sure that the voltage and capacity of the power supply cable conform to the data shown on the plate located under the protective cover. Do not remove this plate for any reason.

The power supply cable plug and the wall socket must be of the same type and conform to the current electrical system regulations. Check that the power line is adequately earthed.

On the power line, install an all-pole disconnect switch with minimum contact gap of 3 mm located at an easily accessible position near the appliance.

Do not use reducers, adapters or shunts.

If the power cable is to be replaced, the wire section on the new cable must not be less than 0.75 mm2 ( 3 x 0.75 cable), bearing in mind that the end tobe connected to the appliance must have the earth wire (yellow- green) at least 20 mm longer.

Use only H05V2V2-F cable or similar which has a maximum temperature of 90°C. Any replacement needed should be carried out by a specialised technician who should make the mains connections according to the following diagram.

L = brown N = blue

= yellow-green

The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from non-observance of the above prescriptions or from tampering with any part of the appliance.

26