Instructions for the user

5.ELECTRONIC ANALOGUE CLOCK (ONLY ON SOME MODELS)

The programmer user instructions are valid only for the large oven.

LIST OF FUNCTIONS

MINUTE-MINDER BUTTON

AUTOMATIC LENGTH / SWITCH-OFF TIMING BUTTON

TIME SETTING AND RESET

VALUE DECREASE BUTTON

VALUE INCREASE BUTTON

5.1Setting the time

When the oven is used for the first time, or after a power blackout, the display flashes on and off at

regular intervals. Press the key for 1/2 seconds to stop the display flashing and start setting of the

current time. Press the value modification keys or to increase or decrease by one minute for each time a key is pressed.

Press one of the two value modification keys until the current time appears. The clock will start from the time set 6/7 seconds after the last key is pressed.

At the end of each programmed cooking operation, the clock gives 8 beeps, repeated 3/4 times at intervals of about 1 and a half minutes. The beeps can be stopped at any moment by pressing any key.

5.2Minute-minder

This function does not stop cooking but just triggers the beeps.

-When the key is pressed the display illuminates, appearing as shown in figure 1;

-Press the or keys within 6/7 seconds to set the minute-minder. Whenever a key is pressed, 1 outside segment, representing 1 cooking minute will light up (figure 2 shows 10 cooking minutes).

-The countdown will start 6/7 seconds after the last key is pressed; at the end of it, you will hear the beeps.

-During cooking with countdown, the current time can be displayed by pressing

the key once; press again to return to the minute-minder display.

-At the end of the countdown, the oven has to be switched off by hand, by turning the thermostat and the function selector to 0.

1

2

7

Page 5
Image 5
Smeg SDO10 manual Electronic Analogue Clock only on Some Models, Setting the time, Minute-minder, List of Functions