Instructions for assembly
Dimensions in mm |
1 Minimum distance to adjacent walls |
2 |
3 Outer dimensions of the hob |
4 Cable routing in rear wall |
5 Installation height |
Working surface cut-out
Cut out the worktop recess accurately with a good, straight saw blade or recessing machine. The cut edges should then be sealed so that no moisture can penetrate. The area is cut out as illustrated.
The glass ceramic hob must have a level and flush bearing. Any distortion may lead to fracture of the glass panel.
Make sure that the sealing of the hob is properly seated.
The glass ceramic hob is fastened with clips or with brackets.
Clips
•Drive the clips into the worktop
It is not necessary to adjust the height due to the horizontal stop motion device.
Important! The horizontal drive of the clips must be flush with the worktop (avoid the risk of breaks).
•Position the hob according to the illustration on the left side (a), align it (b) and insert the clips (c).
•Screws may be used to fasten the clips.
Brackets
•Insert the hob and align it.
•From the bottom, insert the brackets with screws in the holes provided for fastening the brackets, align the brackets and screw them tight.
Tighten the screws with a hand screw driver only; do not use a
•In the case of thin worktops make sure that the brackets are correctly positioned. A metric screw must be used on the bracket to balance it.
Important!
There is a risk of breakage if the hob is canted or subjected to stress during instal- lation!
22