GB
Installation
Note
THE INSTALLATION AND FITTING WORK MUST BE CARRIED OUT BY AN AUTHORISED INSTALLATION TECHNICIAN ACCORDING TO APPLICABLE REGU- LATIONS.
Selecting a location
for the hob (see fig. 3)
To install these hobs, a hole with the dimen- sions specified in the figure, must be cut out of the top of the work surface furniture.
The fixing system for these hobs is designed for work surfaces of 20, 30 and 40 mm thick.
Fig. 3 |
The underside of any furniture located verti- cally above the hob must be at a minimum dis- tance of 60 mm.
Anchoring of the hob
(see fig. 4)
Once the hob location has been measured, the sealing strip must be fixed to the undersi- de of the hob.
Attach the fixing clamps as shown in the figu- re, screwing them to the holes in the undersi- de of the hob with the
vided (ø 4.2 mm).
If the furniture thickness is 30 mm or less, use the M5
20/30 mm
40 mm
Fig. 4
The clamps and the sealing strip are included in the delivery contents.
Electrical connections
Before connecting the hob to the electrical supply, check that the voltage and frequency of the supply correspond to those shown on the rating plate on the base of the hob.
The electrical connection should be carried out using a
The supply must include a suitable earth con- nection, in compliance with applicable regula- tions.
If it should be necessary to replace the flexi- ble hob mains cable, the new cable should be
11