Smeg SGR30 manual Maintenance, Part Replacement, Technical Specifications of Electrical Components

MAINTENANCE

Before carrying out maintenance of any kind, disconnect the appliance from the mains. All maintenance must be carried out by authorized personnel only.

6) PART REPLACEMENT

To replace components located inside the barbecue the resistance should be lifted up and secured in the vertical position. Take out the drip pan containing the lava stone and loosen the four screws that are under it (see fig. 8). The work surface can now be detached from the worktop giving access to all internal components.

To reassemble the work surface of the appliance take care not to damage the power cables and

make certain that they are well positioned in the guides along the side of the appliance.

Note: In the event the power cord is replaced, the ground wire must be left longer than the lead wires (fig. 9) and the instructions in the paragraph "ELECTRICAL CONNECTIONS" must be observed.

To reassemble the appliance repeat the steps above in the reverse order.

7)TECHNICAL SPECIFICATIONS OF ELECTRICAL COMPONENTS

To facilitate the task of the installer a table with component specifications is included below.

ELECTRICAL COMPONENTS OUTPUT

	Name		W
Grill			2400
	TYPE AND SECTION OF POWER CABLES
Type		Total output of	Single-phase power supply
of cable		appliance	230 – 240 V ~
Rubber		2400 W	3 X 1.5 mm2 (*)
H05 RR-F
Neoprene		2400 W	3 X 1.5 mm2 (*)
H05 RN-F

FIG. 8

FIG. 9

21