Instructions for the installer
14.INSTALLATION OF THE APPLIANCE
It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990.
This appliance may be installed next to a wall which is higher than the appliance, as shown in the diagram showing the correct installation conditions. Any wall cupboards or shelves must be at a distance of at least 750 mm above the work surface.
14.1 Electrical connection
The I.D. plate with techinical data, registration number and brand name is visibily positioned in the storage compartment.
The plate must not be removed.
If the appliance is connected to the supply by means of a fixed connection, install a multipolar
Connection to the power supply can be fixed or with a plug and socket. In this case, these must be suitable for the type of wire used and comply with the norms in force. For each type of connection, it is vital that the appliance be earthed. Before reconnecting, ensure that the power line is equipped with a suitable earth. Avoid using adaptors as these may lead to overheating.
The connection terminals are located at the rear of the appliance. For electrical connections see following diagram. To access, remove the rear cover.
20
