Smeg WM40T-1 technical specifications Turn on the tap

FAILURE	FAILURE	PROBABLE	THE PROCESS
CODE	INDICATOR	FAILURE	TO BE DONE
			Turn on the tap
			to the end.Water
			may be cut,
			check it.If the
		The water level	problem is still
			continuing,your
		in your machine
			machine will
	The program	is below heater.
			automatically
Err 02	ready light	The pressure of
			stop after a
	blinks.	your water
			while.Unplug
		supply may be
			your machine,
		low or locking.
			turn off the tap
			and apply to the
			nearest
			authorized
			service.
			Clean the pump
	The start/pause	The pump has	filter.If the
			problem
	light and	failed or the
Err 03			persists,apply to
	program ready	pump filter is
			the nearest
	light blinks .	obstructed.
			authorized
			service.(*)
			Shut down your
	The program		machine and
Err 04		Communication	unplug. Turn off
	end light blinks .	error	your tap and apply
			to the nearest
			authorized service.

(*)See the section regarding the maintenance and cleaning of your machine.

52