Smeg WM40T-1 SECTION 2: INSTALLATION , ,

• If you will not use your machine for a long time, unplug your machine,

close the water supply and leave the door open in order to keep the

inside of the machine dry and for prevention from unpleasant odour.

• As a result of the quality control procedures, a certain amount of

water may remain in your machine. This is not harmful for your

machine.

SECTION 2: INSTALLATION

You must pay attention to the following issues before using your washing

machine.

• Transportation screws, which are located at the back side of the

machine, must be removed before running the machine.

• Loosen the screws by rotating counterclockwise by a suitable wrench.

(DIAGRAM-1)

• Remove the screws by pulling them.(DIAGRAM-2)

• To the holes where the transport screws have been removed, insert

the plastic transport screw taps found in the accessories bag.

(DIAGRAM-3)

• The transportation screws, that have been removed from the machine

should be kept in hand for any other transportation necessities.

DIAGRAM-2

DIAGRAM-1 DIAGRAM-3

• Do not install your machine on rugs or similar surfaces.

• For your machine to work silently and without any vibration, it should

be settled on a flat, non-slippery and tough ground.