For Installations in the United States:
“Standard for the Installation of
“National Electrical Code (NFPA 70)” available from: American National Standards Institute,
25 West 43rd Street,
New York, NY 10036
Check your phone listings for the local authorities having jurisdiction over your installation.
Important: Installation and service of an oil fired water heater and burner must be performed by a qualified Oil- Burner Technician to comply with local and provincial or state codes applicable to this type of equipment. All supply equipment, installation, approvals, permits, inspections, etc. are the responsibility of the owner of this water heater. Consult your local authorities for regulations specific to your area.
Safety Warning (Flammable Vapours)
WARNING
FLAMMABLES | Flammable Vapours |
FIRE AND EXPLOSION HAZARD
Can result in serious injury or death
Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance. Storage of or use of gasoline or other flammable vapours or liquids in the vicinity of this or any other appliance can result in serious injury or death.
There is a risk of property damage, personal injury or death from the
Safety Warning (Scalding)
DANGER
Hot water produced by this appliance can cause severe burns due to scalding. The hazard is increased for young children, the aged or the disabled when water temperatures exceed 52°C (125°F). Use tempering valves, also known as mixing valves, in the hot water system to reduce the risk of scalding at
Safety Warning (Carbon Monoxide)
DANGER
Carbon Monoxide Warning
•Follow all vent system requirements by the local authorities having jurisdiction over your installation.
•Failure to do so can result in death, explo- sion or carbon monoxide poisoning.
As with all fuel burning equipment, this heater requires an adequate supply of air for combustion and ventilation. An insufficient air supply can result in poor combustion or the
MAKE SURE THE FLOW OF COMBUSTION AND VENTI- LATION AIR IS NOT RESTRICTED.
Relief Valve Requirements (T&P)
All water heaters must be fitted with a proper temperature and pressure relief valve. These valves must be certified as meeting the requirements of the “Standard For Relief
Valves For Hot Water Supply Systems, ANSI Z21.22/CSA 4.4”.
If this water heater has been exposed to flooding, freezing, fire or any unusual condition, do not put it into operation until it has been inspected and approved by a qualified service technician.
– 4 –