SMSC USB464, USB4640i Chapter 10 DC Parameters, 10.1Maximum Guaranteed Ratings, MIN, MAX, UNITS, Note:, SYMBOL, COMMENTS, PARAMETER, DATASHEET, Figure 10.1 Supply Rise Time Model

High Speed Inter-Chip USB 2.0 Hub and Flash Media Controller

Datasheet

Chapter 10 DC Parameters

10.1Maximum Guaranteed Ratings

PARAMETER	SYMBOL	MIN	MAX	UNITS	COMMENTS
Storage	TSTOR	-55	150	°C
Temperature
Lead				°C	Please refer to JEDEC
Temperature					specification J-STD-020D.
3.3 V supply	VDD33	-0.5	4.0	V
voltage
Voltage on		-0.5	(3.3 V supply voltage + 2) ≤ 6	V
USB+ and
USB- pins
Voltage on		-0.5	VDD33 + 0.3	V	When internal power FET
GPIO10					operation of these pins are
					enabled, these pins may be
					simultaneously shorted to
					ground or any voltage up to
					3.63 V indefinitely, without
					damage to the device as
					long as VDD33 is less than
					3.63 V and TA is less than
					70oC.
Voltage on		-0.5	VDD33 + 0.3	V
any signal pin
Voltage on		-0.5	3.6	V
XTAL1
Voltage on		-0.5	2.0	V
XTAL2

Note: Stresses above the specified parameters may cause permanent damage to the device. This is a stress rating only. Functional operation of the device at any condition above those indicated in the operation sections of this specification is not implied. When powering this device from laboratory or system power supplies the absolute maximum ratings must not be exceeded or device failure can result. Some power supplies exhibit voltage spikes on their outputs when the AC power is switched on or off. In addition, voltage transients on the AC power line may appear on the DC output. When this possibility exists, a clamp circuit should be used.

Voltage		tRT
VDD33			3.3 V	100%
		90%
VSS	10%
	t10%	t90%	Time
	Figure 10.1 Supply Rise Time Model
Revision 1.0 (06-01-09)		56		SMSC USB4640/USB4640i

DATASHEET