3000 PSI Pressure Washer
3.Place spray gun on hook attached to accessory tray on right side of unit (Figure 15).
4.Hang high pressure hose on hook attached to accessory tray on left side of unit as shown on page 5.
How to Use Spray Tips
The
CAUTION
A pressure washer produces a high pressure spray which increases risk of injury and damage to unit.
•NEVER exchange spray tips without locking the safety latch on the trigger.
Follow these instructions to change spray tips:
1.Engage trigger lock on spray gun.
2.Pull back collar on
3.Select desired spray tip:
•For gentle rinse, select white 40° spray tip.
•To scour surface, select yellow 15° or red 0° spray tip.
•To apply chemical, select black spray tip.
Figure 16 — Spray Tip Spray Patterns
Low Pressure
Black
Use to apply
chemical
High Pressure
|
|
| 15° Yellow |
| 0° Red |
40° White | |||||
|
|
|
|
|
|
4.Pull back on collar, insert new spray tip and release collar. Tug on spray tip to make sure it is securely in place.
5.For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray tip too close, you may damage cleaning surface.
6.DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage the pump.
CAUTION
You must attach all hoses before you start the engine.
•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
To apply detergent follow these steps:
1.Review spray tip use.
2.Prepare detergent solution as required by manufacturer.
3.Hang detergent solution on “J” hook attached to accessory tray, as shown in Figure 17.
Figure 17 — Insert Filter into Container
3.Place small filter end of detergent siphoning tube into detergent container.
CAUTION
Keep the chemical injection tube from coming in contact with the hot muffler.
•When inserting filter into a detergent solution bottle, route tube to keep it from inadvertently contacting hot muffler.
4.Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high pressure spray tips (White,Yellow, or Red).
5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump and start engine.
11