3000 PSI Pressure Washer
6.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
7.Allow detergent to soak in between
IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for
Pressure Washer Rinsing
Wash and Rinse Surface
This pressure washer permits regulation of output water pressure by varying the engine speed.The variable pressure control lever found on the front of the engine may be set, as shown in Figure 18:
Figure 18 - Variable Pressure Control
|
|
|
|
|
|
| Pressure | Low | to | High |
|
| Duty | Light | Medium | Heavy |
|
| Application | Auto | Concrete | Paint removal |
|
|
| Boat | Driveway | Degreasing |
|
|
| Furniture | Deck |
|
|
|
|
|
|
|
|
After you have applied detergent, scour the surface and rinse it clean as follows:
1.Apply trigger lock to spray gun.
2.Remove black chemical nozzle from nozzle extension.
3.Select and install desired high pressure nozzle following instructions “How to Use Spray Tips”.
4.Keep spray gun a safe distance from the area you plan to spray.
WARNING
High pressure spray could cause you to fall if you are too close to the cleaning surface.
•Keep spray nozzle between 8 to 24 inches away from cleaning surface.
•Operate this unit on a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
5.Adjust spray pressure by sliding variable pressure contol lever left or right, as shown in Figure 14 on page 10.
6.Apply a high pressure spray to a small area and then check the surface for damage. If no damage is found, you can assume it is okay to continue rinsing.
7.Start at top of area to be rinsed, working down with same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it with clean water before stopping the engine.
1.Place chemical injection siphon/filter in a bucket full of clean water.
2.Attach black low pressure spray tip.
3.Flush for
4.Shut off engine.
IMPORTANT: Simply shutting OFF engine will not release pressure in the system. When the engine has shut down, squeeze the trigger on the spray gun to relieve the pressure in the hose.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
12