Snapper 020231 Assembly, Preparing Pressure Washer For Use, Remove Pressure Washer From Carton

3000 PSI Pressure Washer

ASSEMBLY

IMPORTANT: Read entire owner’s manual before you attempt to assemble or operate your new pressure washer.

Remove Pressure Washer From Carton

1.Remove parts bag packed with pressure washer.

2.Slice two corners at end of carton from top to bottom so panel can be folded down flat, then remove all packing material.

3.Roll pressure washer out of carton.

Carton Contents

Items in the carton include:

•Main Unit

•Safety Goggles

•Handle

•Plastic Accessory Tray

•High Pressure Hose

•Spray Gun

•Nozzle Extension with Quick Connect Fitting and Spray Tip Holder

•Oil Bottle

•Parts Bag (which includes the following):

•Owner’s Manual

•Engine Manual

•Owner’s Registration Card

•Bag containing 4 multi–colored Quick Connect Spray Tips

•Handle Fastening Hardware Kit (which includes):

•Carriage Bolt

•“L” Bolt

•Plastic Knobs (2)

•“J” Hook

•Chemical Hose Clip

•Self Tapping Screws (4)

PREPARING PRESSURE WASHER FOR USE

If you have any problems with the assembly of your pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-800-317-7833.

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Attach accessory tray to handle, then attach handle to main unit.

3.Add oil to engine crankcase.

4.Add fuel to fuel tank.

5.Connect high pressure hose to spray gun and pump.

6.Connect water supply to pump.

7.Attach nozzle extension to spray gun.

8.Select/attach quick connect spray tip to nozzle extension.

Attach Handle and Accessory Tray

NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear.

1.Slide plastic accessory tray onto handle and align holes in accessory tray with holes on handle (Figure 1).

Figure 1 — Attach Accessory Tray

6