3000 PSI Pressure Washer
2.Secure tray to handle with self tapping screws using a #2 phillips screwdriver. Ensure screws are tight but not crushing the plastic accessory tray.
3.Place handle assembly onto handle supports connected to main unit. Make sure holes in handle align with holes on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Handle
Align Holes
Handle
Supports
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.
4.Insert “L” bolt through hole on right side of handle (viewing from handle side of unit) and attach plastic knob.Tighten knob by hand (Figure 3).
7.Pinch chemical hose and slide it into metal clip as shown in Figure 5.
Figure 5 — Slide Chemical Hose into Metal Clip
8.Tilt unit up by handle and attach metal clip to rib on center underside of accessory tray (Figure 6). Slide chemical hose through metal clip so that it is tight but not kinked.
Figure 6 — Slide Metal Clip onto Accessory Tray Flange
Figure 3 — Secure Handle
5.Insert carriage bolt through left side hole from outside of unit and attach a plastic knob from inside of unit (viewing unit from the handle side).Tighten by hand (Figure 3).
6.Insert “J” hook into second from left slot in accessory tray (Figure 4).
Figure 4 — Install “J” Hook on Accessory Tray
Add Engine Oil and Fuel
•Place pressure washer on a level surface.
•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
NOTE: Check oil often during engine
7
