Snapper 1687099 installation instructions Danger, General Operation, Installation Instructions

Installation Instructions

Clean-Out Tool Kit

Part No. 1687099

319 / 520 / 551 Single Stage, 5-13 HP Intermediate or Large Frame Snowthrowers

3

				Kit Contents:
				Ref.	Part No.	Qty.	Description
			5	1	1733209	1	CLEAN-OUT TOOL
				2	1726727	1	BRACKET, Lower
			4
11				3	1726728	1	CLIP
	1			4	1726995	1	SPACER, 1-1/4” Long
				5	1678392	1	SPACER, 11/32” Long
	10	7		6	1960727	1	SCREW, Slotted, 10-24 x 2-1/2
9			6	7	1960589	1	SCREW, Phillips Head, 10-24 x 3/4
				8	1933896	1	NUT, Nylock, 10-24
				9	1960729	1	CAPSCREW, 5/16-18 x 1
		8		10	1960730	1	CAPSCREW, 5/16-18 x 2
			12	11	7071880	1	DECAL, Danger
				12	1931338	1	Carriage Bolt, 5/16-18 x 1-3/4
			2
Figure 1. Contents

This kit is to install a clean-out tool on a variety of snowthrowers.

WARNING

Before beginning any service work turn off ignition, and disconnect the spark plug wire.

GENERAL OPERATION

After installation of the clean-out tool kit, make sure clean-out tool is attached to handle on machine. Do not operate the machine without the clean-out tool properly stored on the handle.

Upon completion of installation of clean-out tool, keep these instructions and warnings with the Operator’s Manual.

Note: For proper use of clean-out tool it may be neces- sary on some models to remove the wire guard from the chute.

CLEARING A CLOGGED DISCHARGE CHUTE

Hand contact with the rotating impeller inside the dis- charge chute is the most common cause of injury associ- ated with snowthrowers. Never use your hand to clean out the discharge chute.

To clear the chute:

1.SHUT OFF THE ENGINE.

2.Wait 10 seconds to be sure the impeller blades have stopped rotating.

3.Always use a clean out tool, not your hands.

DANGER

Do not clean out discharge chute with hands. Contact with moving parts inside chute will cause serious injury. Use clean out tool provided with machine. Use the following procedure to remove objects or clear the chute:

1.Stop the engine. Remove the key

2.Wait 10 seconds to be sure the auger/impeller blades have stopped rotating.

3.Always use the clean-out tool. DO NOT use your hands.

1