Snapper 1687099 InstallationInstructions, Clean-OutTool Kit, Decal Installation

Installation Instructions Clean-Out Tool Kit

C

B

A

Figure 2.

A. Existing Danger Decal C. New Danger Decal

B. Discharge Chute

INSTALLATION

Decal Installation

1.Clean and dry existing danger decal (A, Figure 2) and surrounding area.

2.Apply new decal (C) by removing the backing from decal and placing directly over existing decal (A) aligning top edges of both decals.

Clean-Out Tool Installation

(CHANNEL HANDLE MODELS)

1.Remove existing hardware (A, Figure 3) from upper back hole on left side handle (C) as shown.

2.Using square hole install lower bracket (B) into upper back hole on left side handle (C) as shown. Secure with existing hardware (A).

3.Measure 16-3/8” from top of bracket (A, Figure 4) to center of handle (B). Center punch and drill a new 13/64 hole (B) in handle.

Note: If using a cab with snowthrower locate hole (B) 1” from edge. See inset in Figure 4.

4.Attach clip (D) to handle (H) securing with #10-24 x 3/4 screw, 11/32 spacer (C), and #10-24 nut (F) mounting through new hole (B).

5.Attach clean out tool (G) to handle (H) by first placing pointed end into bracket (A), then pushing hand grip into clip (D).

6.Read and follow warnings when using the clean-out tool.

C

A

A

B

Figure 3. Mounting Lower Bracket (Channel Handle)

A. Existing Hardware C. Handle, LH B. Lower Bracket

B
	F
C
D	E
16-3/8”
H	G
A
	B
	1”

Figure 4. Mounting Clean-Out Tool (Channel Handle)

A. Bracket	F. Locknut, #10-24
B. New Hole, 13/64”	G. Clean-Out Tool
C. Spacer, 11/32,	H. Handle, LH

D.Clip

E.Screw, Phillips, #10-24 x 3/4

2