Snapper 1687099 installation instructions Installation Instructions, Clean-OutTool Kit

Installation Instructions Clean-Out Tool Kit

D

B

A

E

C

Figure 7. Mounting Lower Bracket (520)

A. Wing Lock Knob	D. Handle, LH
B. Lower Bracket	E. Carriage Bolt,
C. Screw, Curved Head	5/16-18 x 1-3/4

(520 MODELS)

1.Remove wing lock knob (A, Figure 7) and carriage bolt (E) or screw (C) from hole on left side handle (D) as shown. Discard screw (C) if it was used originally.

2.Using square hole install lower bracket (B) into hole on left side handle (D) as shown. Secure with existing or new 5/16-18 x 1-3/4 carriage bolt (E) and wing lock knob.

3.Measure 15-3/8” from top of bracket (A, Figure 8) to center of handle (B). Center punch and drill a new 13/64 hole (B) in handle (H).

4.Attach clip (D) to handle (H) securing with #10-24 x 2-1/2 screw, 1-1/4” spacer (C), and #10-24 locknut

(F) mounting through new hole (B).

5.Attach clean out tool (G) to handle (H) by first placing pointed end into bracket (A), then pushing hand grip into clip (D).

6.Read and follow warnings when using the clean-out tool.

(319 MODELS)

Mount to right hand side handle of unit following the same instructions for the 520 models. Rotate position of new clean-out hole (B, Figure 9) approximately 30 degrees from existing bail hole (C) to avoid interference of bail operation.

	F
B
C
D	E
H
15-3/8”
	G
A

Figure 8. Mounting Clean-Out Tool (520)

A. Bracket	F. Locknut, #10-24
B. New Hole, 13/64”	G. Clean-Out Tool
C. Spacer, 1-1/4”	H. Handle, LH

D.Clip

E.Screw, Slotted, #10-24 x 2-1/2

B	A
	B
C	C
	C
	B
A	Top View
	Cross Section View

Figure 9. Hole Location 319 Models

A. HandleC. Existing Bail Hole B. New Clean-Out Tool Hole

Form No. 1727771-02

Rev. 01/2007

TP 200-4147-02-SK-SN

MANUFACTURING, INC .	Briggs & Stratton Yard Power Products Group
500 N Spring Street / PO Box 997	Copyright © 2007 Briggs & Stratton Corporation
	Milwaukee, WI USA. All Rights Reserved
Port Washington, WI 53074-0997 USA

4