7
Normal Removal & Installation

WARNING

OPERATION WITHOUT TURBO & CATCHER
For operation without turbo, the mower deflector
MUST be properly installed in the down position and
retained by the spring latch (see turbo operator’s
manual).
Figure 11. Normal Removal & Installation (Prestige Shown)
A. Tubes
B. Hair Pin Clip
C. Frame Spacers
D. Bags
E. Clevis Pin
F. Cover
G. Clip
E
F
D
B
C
A
G

NORMAL REMOVAL & INSTALLATION

Removal
1. Disconnect the tubes (A, Figure 11) from the turbo
and remove them from the catcher.
2. Remove the hair pin clip (B) and clevis pin (E) secur-
ing the cover (F). Disconnect the cable (see Figure
8). Remove the cover (F).
3. Remove and empty the bags (D).
4. Remove the catcher frame from the frame spacers
(C).
Installation
1. Mount the catcher frame on the frame spacers (C,
Figure 11).
2. Install the bags (D).
3. Install the cover (F). Secure with the clevis pins (E)
and hair pin clips (B).
4. Connect the cover cable (Figure 9).
5. Insert the tubes (A, Figure 11) into the catcher and
connect to the turbo. Be sure the clip (G) is secured
over the top of the turbo flange nut.